Zartek ZA-601 Instruction Manual - page 12
11
Step 4
Handset
Caller unit
CALL
Beep!
Beep!
The “P” will stop flashing and remain steady
once the unit received the ID code.
After 5-10 seconds, sound two beeps
confirming the handset has received the ID
code and the door bell indicator 2 goes off.
Step 5
CALL
8
Take out batteries, set the yellow dip switch
7 back to NORMAL position.
7
OFF
ON
CHANNEL
NORMAL
PAIRING
1 2 3
Upon hearing the two confirmation beeps
from the Caller unit, press the button
8 to return to normal operation.
Basic Programming procedure
• Select the same channel on the dip switches in the battery compartment for the single button
caller unit as displayed on the handset. There are 2 dip switches for channel selection (see above).
If programming a four button caller unit be sure to press the appropriate button (see above)
that corresponds to the channel on the handset as all channels are already allocated to buttons.
• Set dip switch 3 in the caller unit to PAIRING and insert AA batteries.
• On the handset press the red handset button 8 and the blue handset button 9 together.
The unit will turn on and display the selected channel and a flashing P to indicate programming
mode.
• Press the button 1 on the caller unit, and the handset will beep twice and the P will stop
flashing and stay on. If nothing happens, check the channels selected and reset the door station
by removing the batteries/power.
• Turn the handset off and on again without pressing the blue handset button 9 to exit
programming mode.
• Inside the caller unit, set dip switch 3 to NORMAL. The intercom is ready to be used.
CH
˚C
Outdoor
CH
˚C
Outdoor
D i !
D i !