ZD T7AH-2400 Instruction Manual - page 19
35
36
◇Assigning Mixing Values
Press the DOWN and SELECT keys simultaneously to access the Function Mode.
In Function Mode, use the UP or DOWN keys to select the desired PROG. MIX screen
Press the SELECT key to select RATE.
Using the stick or switch that is assigned to the master channel, move that stick or
switch in the desired direction that you wish to adjust the mix value.
Press the INCREASE or DECREASE key to adjust the mix value. The values are
adjustable from -125% to +125%.
◇Assigning an Offset
Press the DOWN and SELECT keys simultaneously to access the Function Mode.
In Function Mode, use the UP or DOWN keys to select the desired PROG. MIX screen
Press the SELECT key to select OFFSET.
To establish the offset position, use the INCREASE or DECREASE keys to change
the value to the desired point. The stored offset value will appear on screen.
To change the offset value, simply use the INCREASE or DECREASE key to change
the value. Pressing the CLEAR key will reset the offset to 0.
◇Assigning a Switch
Press the DOWN and SELECT keys simultaneously to access the Function Mode.
In Function Mode, use the UP or DOWN keys to select the desired PROG. MIX screen.
Press the SELECT key to select SW.
Use the INCREASE or DECREASE key to select the desired switch to turn on/off
the mix.
● ON: Mixing Always On ● MIX: Mixing Switch Toward Self
● Flap 0: Flap Switch in Flap 0 Position ● Flap 2: Flap Switch in Flap 2 Position
● Gear: Gear Switch
◆
Timer
TheT7AH-2400 features an onscreen timer with three programming options.
INH:
Inhibit- In this mode the timer is turned off.
Down-T:
Down Timer- The countdown timer allows a preset time in ten-second intervals up
to 59 minutes and 50 seconds to be programmed, and when that time before the
expiry of 10 S, a beeper will sound for 10 seconds.
STOP-W:
Stopwatch- The stopwatch function is a simple count-up timer that displays
minutes and seconds up to 59 minutes and 59 seconds. And when that time before
the expiry of 10 S
, a beeper will sound for 10 seconds.
When the DOWN-T or STOP-W function is selected, the timer will be displayed on
the main screen. The following buttons are used in conjunction to operate the time
r function:
[PROG.MIX1]
THRO THRO ON
RATE: 0%
0%
SW:ON
OFFSET: 0
Press to enter PROG MIX
Press to enter
Function Mode
Press to return
value to default
Press to highlight
OFFSET
Press to adjust
OFFSET
value
When choosing the throttle idle speed as switch to activate of the timer, it
will display the percentage of throttle idling for choosing. It is independent of
the set.
CLEAR key:
Used to reset the timer to the preset time or to reset the stopwatch timer to 0:00.
SW:ADJUST ADJUST
THRO IDL Switch of throttle trip percentage
Press to select TIMER
Press to enter
Function Mode
Press the CLEAR key
to reset the DOWN-T
to 10:00 minutes
Press the SELECT key
to access INH, DOWN-T
or STOP-W
Press the INCREASE or DECREASE
key to set the down timer
[ TIMER ]
MODEL 1
DOWN-T
00:00
SW:ADJUST