ZD T7AH-2400 Instruction Manual - page 24
45
46
◇To Reset a Model
● Press the DOWN and SELECT keys simultaneously, then turn on the transmitter.
● Press the UP key until MODEL RESET appears on screen.
● Press the SELECT key until DATA RESET is highlighted.
● Pressing the CLEAR key will reset the model memory to factory default settings.
◇To Reset the Integrated Timer
● Press the DOWN and SELECT keys simultaneously, then turn on the transmitter.
● Press the UP key until the MODEL RESET function appears on screen.
● Press the SELECT key until INTEg-T is highlighted.
● Pressing the CLEAR key will reset the INTEG-T to factory zero.
◆Enhanced wireless Trainer
The T7AH-2400 offers a Wireless Trainer Function. Premise is the transmitter's
and transmitter's sets are the same.
To Enter the Trainer Mode:
Press the DOWN and SELECT keys simultaneously, then turn on the transmitter.
Press the UP key until TRAINER function appears on screen.
Press the INCREASE or DECREASE key to activate or close Trainer function, then
TRAINER TRIM only used as a trainer switches.
◆Throttle Recovery
The T7AH-2400 has a unique throttle trim recovery feature. Throttle Recovery
stores the last known throttle trim position once throttle restore function is
activated. That stored position is then recalled by moving the throttle trim up
(open) one notch when the throttle trim is moved to the full down (closed) position.
This makes shutting off the engine and restarting it with the correct trim position easy.
To Activate the Throttle Recovery Function
Press the DOWN and SELECT keys simultaneously, then turn on the transmitter.
Press the UP key until THRO RECOVERY appears on screen.
Press the INCREASE or DECREASE key to turn on/off the Throttle Recovery function.
◇To Activate the Throttle Recovery Function
Press the DOWN and SELECT keys simultaneously, then turn on the transmitter.
Press the UP key until THRO RECOVERY appears on screen.
Press the INCREASE or DECREASE key to turn on/off the Throttle Recovery function.
[MODEL RESET]
MODEL 1 ACRO
DATA RESET
INTEG-T
Press to enter MODEL RESET
Hold while turning
on transmitter
Press to select
RESET or INTEG-T
Press to reset
data or timer
00:00:34
[MODEL RESET]
MODEL 1 ACRO
DATA RESET
INTEG-T
Press to enter MODEL RESET
Hold while turning
on transmitter
Press to select
RESET or INTEG-T
Press to reset
data or timer
00:00:34
INCREASE and DECREASE key
INCREASE and DECREASE key
Press to enter
function main screen
Press to enter
COPY screen
Press to copy
selected model
INH
TRAIN RECOVERY
[ ]
Press to enter THROTTLE RECOVERY
◆Pole mode
The T7AH-2400 have in four different control rod "mode" (0, 1, 2, 3). Different
mode corresponding to operation function of different control rod. Usually, set in
"mode" 1.