ZD T7AH-2400 Instruction Manual - page 5
7
8
Input key and scroll under the condition of input, all will make a sound to
confirm the correct.
Add keys and Decrease keys have rapidly increasing or decreasing function
(continuous pressure which will rapidly increasing or decreasing)
Sometimes occur numerical unchanged, but have the confirmed sound,
that is because of the numerical value in the decimal point, no suggested
in the LCD screen, but the internal value have changed.
Available when
to select function
available when to
select setted project
{
}
up key
down key
UP
DN
select key
SEL
ENTER
LIST
Alert mode switch
DN
SEL
( press with simultaneously)
list
CONT
+
-
SEL
Change screen light and shade
increase key
decrease key
clear key
available when to
set the information
7. 2 Inputing mode and function selection
Boot screen
S
as described below:
SCROLL UP and SCROLL DOWN, the two keys used to flip menus. The SELECT is
select key, used to select the menu, ADJUST INCREASE and ADJUST DECREAS
are used to change the specific settled date under the options. CLEAR is reseted
button, make the date to reset the default values.
In additon, these keys has some combination setting functions:
1 In the boot screen, pressing SCROLL DOWN and the SELECT keys
simultaneously, you can enter the system setup menu interface, in this display
interface, pressing the SCROLL UP and SELECT keys, you can enter the system
setup menu list interface. At the same time in SCROLL DOWN and SELECT keys
,you can return to the system setup menu interface, once again, then you can
return to the main display interface.
2, After startup, pressing SCROLL DOWN and SELECT keys simultaneously, you
can enter the function setup menu interface, pressing SCROLL UP and SELECT
buttons, you can enter the function setting menu list. When in the interface, you
can press SCROLL DOWN and SELECT keys simultaneously, exist to function
setup menu interface, then press again, go back to the main display interface.
DECREASE、CLEAR, The specific function of this several LCD operation buttons
The text below the key panel figure state:
Panel SCROLL UP、SCROLL DOWN、SELECT、ADJUST INCREASE、ADJUST
Eight, aircraft quick setup guide
◇
choose aircraft type
Turn the power and press DOWN and SELECT keys simultaneously, the RC turns
into the system setup mode.
Press the UP or DOWN key until TYPE SELECT appears on the screen.
According to the UP or DOWN until the SELECT button, by appear on the screen.
Press INCREASE or DECREASE key, the black triangle towards or in "HELI" and
◆
Servo Reversing
Press to enter TYPE SELECT
[TYPE SELECT]
MODEL 1
HELI
INCREASE and DECREASE key
Hold while turning on transmitter
ACRO
Accept new model type
CHANNGE
SCROLL UP
DOWN
SELECT
ADJUST
INCREASE
ADJUST
DE CR EA SE
CLEAR
MODEL 0 HELI0001
12.5ms FRAME RATE
10.3V
Model number
Launch control data update cycle
Current control the plane type
Throttle fine
-tuning quantity
display
Rudder fine- tuning
quantity display
Aileron fine-tuning quantity display
Elevator fine-
tuning quantity
display
UP
SEL
( press with simultaneously)
SEL
+
-
(press with
simultaneously)
with