ZD T7AH-2400 Instruction Manual - page 6
9
10
◇
To Access Servo Reversing
Turn the power on and press the DOWN and SELECT keys simultaneously to enter
the function mode.
Press the UP and DOWN keys until REVERSING SW appears on the screen.
Press the SELECT key to select the desired channel, and then press the INCREASE
or DECREASE key reverse or normal servo direction.
◆Travel Asjustment
Insert English instruction 26 page below
◇To Access Travel Adjustment
Turn on the power and press the DOWN and SELECT keys to enter into the function
model press the UP or DOWN key until TRAVEL ADJUST appears on the screen.
Press selected key to move cursor arrow to the desired channel.
Note: if your aircraft flaps is controlled by two independent servos, please see page
44. The rear wing type for selected explicitly pointed out the programming
flaperon.
◆
Only aircraft adjust for HELI, just have this feature setup.
T7AH-2400 offers four independent pitch curves, each with up to five adjustable
points. This function allocates a separate pitch curve setting during normal, stunt
1, stunt 2 and hold modes. Once the pitch curves are adjusted, each can be
activated in flight using the three-position flight mode and throttle hold switches.
Each of the five points of the pitch curve are independently adjustable from 0–
100%. These five points correspond to low, 25%, mid, 75% and high stick positions.
See Page 94 for more details on setting up pitch curves.
◇To Access the Pitch Curve Function
Turn the power on and press the DowN and SELECT keys simultaneously to enter
the function mode.
Press the UP or DOWN key until PITCH CURVE NORM appears on the screen.
Press the SELECT key to select the stick position that you wish to adjust the pitch.
● L = Low
● 1 = 25%
● 2 = 50%
● 3 = 75%
● H = High
Press the INCREASE or DECREASE key to adjust the pitch position.
Recommended Initial Pitch Settings
● L= -4º
● 2= 5º
● H= 9º
Note: For more information about setting up pitch curves, see continue pages.
◆Adjust the three sections of switch with corresponding normal model under the
throttle curve Only aircraft adjust for HELI, just have this setup function.
[REVERSING SW]
GEAR
Press to select REV. or NORM
Press to enter REVERSE
Press to enter
Function Mode
Press to select
desired channel
NORM
ch 1 2 3 4 5 6 7
REV.
[TRAVEL ADJUST]
THRO
H 100%
L 100%
ELEV
D 100%
U 100%
AILE
L 100%
R 100%
RUDD
L 100%
R 100%
Selected channel
Press to enter
TRAVEL ADJUST
Press to enter
Function Mode
Press to return
value to default
Press to select
desired channel
Press to adjust value
[PITCH CURVE]
Point-3
51
51
INH
1
2
3
H
L
IN
Press to enter
PITCH CURVE
Press to enter
Function Mode
Press to select
desired points
Press to change
OUT
NORM
"ACRO" appear alternately, if not show "the YES-> CLEAR KEY, it means the
current plane is the type, if not be, it means you can choose the aircraft type by
pressing CLEAR key.