Zebex Z-3151HS User Manual - Programming Guide
Advanced Handheld High-Speed Laser Scanner
11
U
SER
’
S
M
ANUAL
Programming Guide
Scanning a series of programming barcode labels can configure the scanners. This
allows decoding options and interface protocols to be tailored to a specific application.
The configuration is stored in non-volatile memory and will not be lost by removing
power from the scanner.
The scanner must be properly powered before programming. For RS-232C type
scanners, an external power adapter must be used to supply DC power to the scanner.
If a keyboard emulation type scanner is used with an IBM PC/XT/ AT, PS/2 or any fully
compatible computers, power will be drawn from the keyboard port. No external
power adapter is required. If keyboard emulation type scanner is used with any other
non IBM PC compatible computers, an external power adapter may be needed.
During the programming mode, the laser scanner will acknowledge a good and valid
reading with a short beep. It will give long beeps for either an invalid or bad reading.
Programming Options
Programmable options are divided into four groups. The first group includes the
options that show the general behavior of the laser scanner. The second group governs
the operation of different interfaces, RS-232 serial ports, keyboard, and USB. The third
group sets the decoding parameters for each barcode symbology. The last group is
about more advanced data formatting.
Default Parameters
This table gives the default settings of all the programmable parameters. The default
settings will be restored whenever the laser scanner is in programming mode and the
"Reset" programming label is scanned.