Zebex Z-3151HS User Manual - Connecting to A Host

Advanced Handheld High-Speed Laser Scanner 

3 

U

SER

’

S 

M

ANUAL

Connecting to a Host

1. 

 Turn off the host system. 

2. 

Connect the 10-pin RJ45 male connector into the jack on the scanner until a 

“click” is heard. If the scanner is powered directly from the host supply, skip to 

step 5. 

3. 

 If necessary, plug the L-shaped plug of the power supply into the power jack on 

the cable. 

4. 

Connect the power supply into an AC outlet. (Double check that the AC input 

requirement of the power supply matches the AC outlet.) 

5. 

Connect the cable to the proper port on the host system. 

6. 

Turn on the host system. 

7. 

If the scanner is properly installed, the red, green, blue LED will turn on once and 

3 power-up beeps will be heard. 

8. 

Set the scanner to communicate with your particular POS terminal by scanning 

the appropriate barcodes. The programming procedure varies on different 

terminals. Please refer to the Programming section for more information. 

9. 

Verify that the scanner is successfully reading barcodes and transmitting correct 

information to the terminal.