Zebex Z-3151HS User Manual - page 71

Advanced Handheld High-Speed Laser Scanner 

65 

U

SER

’

S 

M

ANUAL

Appendix 3: Multi-Barcode Editor

Introduction

The multi-barcode editor function allows users to set up the sequence of barcode data 

transmission. After the configuration, the scanner would transmit data in the pre-

programmed sequence even if the user doesn’t scan barcodes in the correct order. 

Users can set up the sequence of up to 5 pieces of barcode data.   

The three parameters to be programmed are: barcode type, barcode length and check 

digit.  

Set up as “0” if the barcode length is not required; set up as “NUL” is there is no need 

to check the first digit of the barcode value.   

Start of Configuration

Set up the 1

st

barcode 

symbology 

Set up the 2

nd

barcode 

symbology 

End of Configuration 

Use the ASCII table (Appendix 4) to set up barcode length and first digit 

checkup. Be sure to enable the full ASCII code 39 option before you start 

and read the “Set” label to set your choice into memory.   

Start 

Set up data transmission sequence 

and requirement 

End

Scan the “Start of 

configuration” 

barcode 

Set up 

barcode type 

Set up   

barcode type 

Set up

Scan the “End of 

configuration” barcode 

Check the first 

digit 

Set up 

barcode length 

Set up   

barcode length 

Check the first 

digit 

Scan the “Multi-

barcode enable” 

barcode 

Read the “Full ASCII 

code 39” barcode 

Scan the “Start to 

edit multi-barcode” 

barcode