Zebra 2844 Printer User Manual - Adding A New Transfer Ribbon

Replacing Supplies

If labels or ribbon run out while printing, leave the printer power on while

reloading (data loss results if you turn off the printer). After you load a new

label or ribbon roll, press the Feed button to restart .

Always use high quality, approved labels, tags and ribbons. If adhesive

backed labels are used that don’t lay flat on the backing liner, the exposed

edges may stick to the label guides and rollers inside the printer, causing the

label to peel off from the liner and jam the printer. Permanent damage to the

print head may result if a non-approved ribbon is used as it may be wound

incorrectly for the printer or contain chemicals corrosive to the print head.

Approved supplies can be ordered from your dealer.

Adding a New Transfer Ribbon

If ribbon runs out in the middle of a print job, the indicator lights red and

the printer waits for you to add a fresh roll.

1. Keep the power on as you change ribbon.

2. Open the top cover, then cut the used ribbon so you can remove the

cores.

3. Load a new ribbon roll. If necessary, review the Ribbon Loading steps.

4. Close the top cover.

5. Press the Feed button to restart printing.

Replacing a Partially Used Transfer Ribbon

To remove used transfer ribbon, perform the following steps.

1. Cut the ribbon from the take-up roll.

2. Remove the take-up roll and discard used ribbon.

3. Remove the supply roll and tape the end of any fresh ribbon to prevent

it from unwrapping.

When reinstalling a partially used supply roll, tape the cut end onto the

empty take-up roll.

22

980487-001A