Zebra 400 User Manual - This Chapter.

12

PA/PT400 & PA/PT 403 User’s Guide

9. Refer to Figure 7. If it’s not already in place, install the tear bar

in the media access door. Gently lift the tab on the bar to move

it over the protrusion on the door. Make sure the lip of the bar

(inset, Figure 7) faces out of the printer.

If you’re using direct thermal media, continue on with step 10.

However, if you’re using thermal transfer media, you must also

install a ribbon cartridge. Proceed to “Loading the Ribbon “ in

this chapter.

Tab

Lip

Protrusion

10. Close the printhead and the top cover.

11. Swing up the media access door, ensuring that the media ex-

tends over the tear bar (refer to Figure 8).

12. Lift to hook

the top of the

media access

door over the

top cover.

13. Push in the

bottom of the

media access

door to close.

14. Turn on the

printer or press

the Feed button

if the printer is

already on.

Tear Bar

F

IGURE

 7

F

IGURE

 8