Zebra 400 User Manual - Label Specifications

PA/PT400 & PA/PT 403 User’s Guide

39

Label Specifications

Label/Tag Width

1" to 4.25" (25.4 mm to 108 mm)

Fanfold Width

3.5" to 4.25" (89 mm to 108 mm)

Label/Tag Length

0.5" to 10" (1 2.7 mm to 254 mm) 400 Series;

0.5” to 70”  (1 2.7 mm to 1778 mm) 403 Series

Inter-label Gap.

08" to .16" (.12" preferred)

2 mm to 4 mm (3 mm preferred)

Label/Tag Thickness

.0030- to .0106- (.076 mm to .269 mm)

Label RollSize:

Max.Diameter

2.1" (53.3 mm)

Inner Core

1" (25.4 mm)

Use Zebra-brand direct thermal or thermal transfer roll

media that is outside wound. Media may be reflective

(black mark) sensing or transmissive sensing, die-cut,

notched, or continuous.

For die-cut labels, use only full auto dies.

Media Requirements

Notched media must have a 0.5" (1 2.7 mm) wide x

0.094” (2.4 mm) long cutout located in the center of the

roll.  The reflective media black marks must be located in

the center of the roll.

Minimum Black Mark Dimensions:

Mark width: 0.5” (12.7mm) perpendicular to the edge of

the media.

Mark length: 0.094” (2.4 mm) parallel to the edge of the

media.

Memory/Communications Specifications

ROM Memory

1 MB flash (400 Series); 2MB flash (403 Series)

RAM Memory

512 KB DRAM (400 Series); 2 MB DRAM (403 Series)

Communications

RS-232 serial port (RJ45 connector)

Configurable Baud rate (from 110 to 19,200 Baud),

parity and data bits.

Software (X-ON/X-OFF) or hardware (DTR/STR)

communication handshake protocols.

Error detection CRC protocol

Optional infrared wireless link (meets IrDA 1.1

specifications) 2,400 to 115,200 Baud rate