Zebra 400 User Manual - page 2

Proprietary Statement

This manual contains proprietary information of Zebra Technologies Corporation.  It is intended

solely for the information and use of parties operating and maintaining the equipment de-

scribed herein.  Such proprietary information may not be used, reproduced, or disclosed to any

other parties for any other purpose without the expressed written permission of Zebra Technol-

ogies Corporation.

Product Improvements

Since continuous product improvement is a policy of Zebra Technologies Corporation, all spec-

ifications and signs are subject to change without notice.

FCC Compliance Statement

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of FCC Rules.  These limits are designed to provide reasonable

protection against harmful interference in a residential installation.  This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.  However, there is

no guarantee that the interference will not occur in a particular installation.  If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try and correct the interference by

one ore more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected

 • Consult the dealer or an experienced Radio/TV technician for help.

NOTE: This unit was tested with shielded cables on the peripheral devices.  Shielded cables

must be used with the unit to insure compliance

“The user is cautioned that any changes or modifications not expressly approved by Zebra

Technologies Corporation could void the user’s authority to operate this equipment.”

Canadian DOC Compliance Statement

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital

apparatus as set out in the radio interference regulations of the Canadian Department of Com-

munications.

Liability Disclaimer

Zebra Technologies takes steps to assure that its published Engineering Specifications and

Manuals are correct; however, errors do occur.  Zebra Technologies Corporation reserves the

right to correct any such errors and disclaims liability resulting therefrom.

No Liability for Consequential Damage

In no event shall Zebra Technologies Corporation or anyone else involved in the creation, pro-

duction, or delivery of the accompanying product (including hardware and software) be liable

for any damages whatsoever (including, without limitation, damages for loss of business prof-

its, business interruption, loss of business information, or other pecuniary loss) arising out of

the use of or the results of use of or inability to use such product, even if Zebra Technologies

Corporation has been advised of the possibility of such damages.  Because some states do

not allow the exclusion of liability for consequential or incidental damages, the above limitation

may not apply to you.

Copyrights

The copyrights in this manual and the system described therein are owned by Zebra Technolo-

gies Corporation.  All rights are reserved.  Unauthorized reproduction of this manual or the

software in any of the system modules may result in imprisonment of up to one year and fines

of up to $10,000 (17 U.S.C.506).  Copyright violators may be subject to civil liability.

All products and brand names are trademarks of their respective companies.  All rights re-

served.

©

2001 Zebra Technologies Corporation