Zebra 400 User Manual - Operator Controls
Other manuals for 400:
User Manual
Manual is about: Zebra Technologies User's Guide Printers 400, 600
of
44
20
PA/PT400 & PA/PT 403 User’s Guide
Operator Controls
Refer to Figure 17.
Power Button
• Press to turn on the printer.
• To turn off the printer, press and hold until the Power LED
flashes once. (Holding the button for approximately two sec-
onds acts as a safeguard. That way, no data will be lost if the
button is accidentally pressed or bumped.)
CAUTION. The power should be turned off before con-
necting or disconnecting the communications cable.
Feed Button
• Forces the printer to feed one blank label.
• Takes the printer out of a “pause” condition. (The printer is put
into “pause” by either a software command or an error condi-
tion.) See “Troubleshooting”.
• Used for printer setup and status (see “Feed Button Modes” in
“Troubleshooting”).
Feed
Button
Error
LED
Power
LED
Power
Button
F
IGURE
17