Zebra ZC100 Series User Manual - Printing A Sample Card
Setup
12
Printing a Sample Card
1. Make sure the printer is powered on and ready.
2. From the Printer Ready screen, press the rightmost soft key to go to the
Tools menu.
3. Use the center soft key to move the selection to Print sample cards and
press the rightmost soft key to select.
4. Use the center soft key to select the card(s) to print.
5. Press the rightmost soft key to begin printing.
Installing the Driver
The printer driver is loaded automatically from the Windows Update service when the printer is connected via USB.
The driver may be installed manually by downloading from the Zebra web site (www.zebra.com/zc100-info or
www.zebra.com/zc300-info).
You cannot download the driver to a mobile device.
You need Internet access to download a driver.
Manual Feed
Single cards can be inserted via the manual feed slot located at the front of
the printer just below the input hopper. Manual feed is selected via the
driver. When the manual feed slot illuminates green, insert the card in the
same orientation as the cards loaded into the input hopper. When the card
is finished printing, it will be sent to the output hopper.