Zebra ZC100 Series User Manual - Replacing The Printhead
of
34
Troubleshooting
27
Replacing the Printhead
Removal
1. Open the top cover
2. Push the printhead upward and then rotate to release the printhead assembly from the hooks.
3. Disconnect the cable connector from the printhead.
Installation
1. Connect the cable connector to the new printhead.
2. Note the serial number and resistance value of the new printhead.
3. Insert the stabilizer ball into its receptacle on the top cover.
4. Push the printhead upward and then rotate into the hooks.
5. Open the printer driver and click on the Advanced tab, then click on Diagnostics and Calibration, then click on
Commands & Calibration.
6. Under Printhead, enter the serial number and resistance value of the new printhead.