Zebra ZC100 Series User Manual - Ethernet
Troubleshooting
28
Ethernet
Indicators
Orange — Link Speed Indicator
Green — Link Activity Indicator
Issues
If both LEDs are off, the printer has not detected the presence of a network cable. To solve the problem:
• Verify that the network cable is appropriate and has an RJ-45 connector.
• Remove the network cable from the printer. Plug the network cable back in until you hear a positive click. Check
the other end of the cable in the same manner. If the printer still does not detect a cable, then continue.
• Connect the printer to a known good network. If the printer is still unable to detect the network cable, contact
Technical Support for assistance.
Off
No link (disconnected)
1 Blink
The LED blinks once (one blink, pause, one blink,
etc.) when a 10Base link has been established.
2 Blinks
The LED blinks twice (two blinks, pause, two blinks,
etc.) when a 100Base link has been established.
Off
No link (disconnected)
On
Network link has been established
Blinking
Network activity has been detected