Zektor CVS4 User Manual - Easy, Simple, Instructions!
4
CVS4 Component Video Switch
CVS4 Component Video Switch
Step 1...
Use the analog input connections to switch component
video / composite video / analog audio or any combination
of the above signals to the CVS4’s analog output connec-
tors. Use the digital audio connectors to switch digital au-
dio signals, with full format conversion between the optical
and coax digital audio formats.
If using a hardwired IR controller to operate the CVS4, con-
nect the controller IR cable to the IR / Z-IN jack .
If using a PC (or other serial controller), connect it to the
RS-22 por t using a standard serial cable.
Plug the power module into the CVS4, and plug the module
into a standard A.C. wall receptacle. The standby LED will
light up.
Step 2...
To switch between any of the four inputs, simply press the
button for the desired input. If the CVS4 is in the standby,
it will turn on. The CVS4 will then switch to the selected
input, and the associated LED will light to indicate this.
To place the CVS4 back into the standby mode, press and
release the Power Toggle button. The channel LEDs will all
go blank , and the standby LED will light up. Press the Power
Toggle button again to re -select the previously selected
input.
Step 3...
Use nearly any remote to control your CVS4!
Using any remote to operate the CVS4 is a simple matter of
pairing up the CVS4 with the remote. The remote doesn’t
have to be a universal remote (although it can be), any re -
mote from an old T V or VCR will work just fine.
Using Zektor ’s exclusive Intelligent-IR™, setup is easy! The
CVS4 does all the work!
Turn to the nex t chapter for simple instructions
on how to pair up the CVS4 with any remote!
•
•
•
•
•
•
•
•
•
Step 1: Make the appropriate connections.
R/V L/H C/V
Y/G Pb/B Pr/R
R/V L/H C/V
Y/G Pb/B Pr/R
R/V L/H C/V
Y/G Pb/B Pr/R
R/V L/H C/V
Y/G Pb/B Pr/R
R/V L/H C/V
Y/G Pb/B Pr/R
DIGITAL
AUDIO
1 2 3 4 OUT
4 OUT OUT
1 2 3
9VDC
1
2
3
4
OUT
RS-232
IR / Z-IN
Z-OUT
To
Cable
Box
To
Cable Box
Digital Audio
To
DVD
To
Game
Console
To Game
Console
Digital Audio
Unused
Input
To
Projector
or
Monitor
To Power
Module
To
Composite
Monitor
w/Analog
Audio
To Home Theater
Receiver’s Digital
Audio Input
To DVD
Digital Audio
Step 2: Press buttons to select an input.
1 2 3 4
Step 3: Or use nearly ANY remote to select an input.
1 2 3 4
1 2 3
4 5 6
7 8 9
0
+ +
_ _
POWER
VOL
CH
Turn to the next chapter for simple instructions
on how to setup the CVS4 for use with
any existing remote!