Zektor CVS4 User Manual - page 5
6
CVS4 Component Video Switch
7
CVS4 Component Video Switch
Three Simple Steps to a Remote!
The CVS4 features Zektor ’s Exclusive Intelligent-IR™, and with ver y
few exceptions can be setup to use any remote you can point at it!
Pick a remote, any remote!
Star t by pick ing the remote you’d like to use with the CVS4.
If the remote you plan on using is not programmable (for
instance, from an old T V ), sk ip the next step.
If you plan on using a universal remote, star t by setting it
up as a remote for a T V or VCR that you do not own. (For
instance if you don’t own a Sony T V, setup your universal
remote to control a Sony T V.)
Step 1: Put the CVS4 into the Setup Mode
The CVS4 is placed into the setup mode by pressing and
holding the Power button for about 4 seconds.
Step 2: Select the Intelligent-IR™ Learn Mode
There are many options available in the setup mode, but for
now all we’re interested in is the Intelligent-IR™ learning
mode. This is selected by pressing the ‘’ button.
Once the ‘’ button is pressed, the standby LED will flash
slower and all the other LEDs will turn off. The CVS4 is
now waiting for new IR codes to be sent from your remote
control.
Step 3: Teach the CVS4 your new remote control codes
On your remote control, press the following buttons, in the
following order:
Power 1 2 3 4 8 9 0
That ’s it! The CVS4 will return to the state it was in before
setup, and will now work with your new remote!
The new control buttons on your remote are...
Power
Toggles the CVS4’s power.
1 - 4
Selects inputs through 4.
8
Turns on the CVS4 (Discrete ON)
9
Turns off the CVS4 (Discrete OFF).
0
Sequences through inputs.
Note:
All remote control codes are saved in non-volatile
memor y and will not be lost during a power failure.
•
•
•
•
•
•
•
1 2 3 4
Step 1: Put the CVS4 into the Setup Mode
Press and hold the Power Button for 4 secs.
The standby LED will blink wildly, and the
selection LEDs will start sequencing to the
right. (You’ll know it when it happens!)
Step 2: Press the ‘1’ button for Intelligent-IR™ learning
1 2 3 4
Once the ‘’ button
is pressed...
Step 3: Teach the CVS4 its new IR codes
1 2 3 4
1 2 3
4 5 6
7 8 9
0
+ +
_ _
POWER
VOL
CH
Press the following sequence of buttons on
your remote control:
Power 1 2 3 4 8 9 0
That’s it! The CVS4 now operates with your
new remote control!
...the standby LED will flash slower,
and all the other LEDs will turn off.