Zektor CVS4 User Manual - page 9
4
CVS4 Component Video Switch
CVS4 Component Video Switch
1 2 3 4
Step 1: Set the CVS4 to the preferred initial power on state
Setup the CVS4 to the
initial power on state
you’d prefer.
Step 2: Save the new initial power on state
1 2 3 4
Start by pressing and
holding the Power
button...
Setting the Initial Power On State
As long as the CVS4 is plugged in, it will remember the previously
selected input in standby mode. When powered up by pressing the
Power button, it will return to that previously selected channel.
However, if power is removed (for instance a plug strip used to pow-
er the CVS4 is turned off ), and then re -applied, the CVS4’s default
behavior is to enter into the standby mode.
I t is possible to change the power on behavior of the CVS4.
To change the power on defaults...
Step 1: Setup the CVS4 to your preferred power on state
.
Use the front panel buttons to setup the CVS4 to the oper-
ating settings you’d like at initial power up.
Step 2: Save the new initial power on state.
First press and hold the Power button.
While continuing to hold the Power button, press and hold
the ‘’ button.
After holding both buttons for about ‘4’ seconds, the dis-
play will blink indicating the new power on defaults have
been accepted.
Test the new initial power on state
You can test the new defaults by either disconnecting the
power supply from the back of the CVS4 or by unplugging
the power supply from the wall.
Reconnect power. The CVS4 will power up into your new
power on default state.
•
1.
2.
3.
•
•
1
2
...while continuing to hold the Power
button, press and hold the ‘’ button.
After about 4 seconds, the display will
flash indicating the new power on state
has been accepted.
3