Zenit BC-1400 Instruction Manual - page 4
4
switch. Ensure switch is off when plugging in.
18.
Use outdoor extension leads. When tool is used outdoors, use only extension cords
intended for outdoor use.
19.
Stay alert. Watch what you are doing. Use common sense. Do not operate tool when
you are tired.
20.
Check damaged parts. Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, free running of moving parts, break-
age of parts, mounting and any other conditions that may affect its operation. A guard or other
part that is damaged should be properly repaired or replaced by an authorized service center
unless otherwise indicated in this instruction manual. Have defective switches replaced by an
authorized service center. Do not use the tool if the switch does not turn it on and off.
21.
Warning Use only accessories or attachments recommended in this instruction man-
ual or in the catalogue of ZENIT ТМ.
22.
Have your tool repaired by a qualified person. This electric tool is in accordance with
the relevant safety requirements. Repairs should only be carried out by qualified persons using
original ZENIT TM spare parts. Otherwise this may result in considerable danger to the user.
safety precautions forbidden actions
1.
Do not operate the power tool in uncomfortable position, with no balance, with
stretched arms or one arm.
2.
Do not lift cutting head with nylon line above the ground level. It may cause operator
injury.
3.
Do not use the tool for other purposes other than trimming lawns.
4.
Do not operate the tool for a long time. Take a break from time to time.
5.
Do not the tool when you are tired, ill or under the influence of alcohol, drugs or
medication.
6.
Do not operate the tool without blade guard installed.
7.
Do not modify the unit in any way.
8.
Do not operate the tool near inflammable liquids.
safety precautions on operating electric brush cutter forbidden actions
1. Power source.
Ensure that the power source to be utilized conforms to the power source requirements speci-
fied on the product nameplate.
2. Power switch.
Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle
while the switch is in the ON position, the power tool will start operating immediately and can
cause serious injury.
3. Extension cord.
When the work area is far away from the power source, use an extension cord of sufficient
thickness and rated capacity. The extension cord should be kept as short as practicable.
4. Make sure the blade guard is properly attached.