Zenit BC-1400 Instruction Manual - page 7
7
4.
Blade guard installation
Install the guard bracket on the gear case with the help of three mounting screws. Install
the blade guard on the bracket with the help of three mounting screws.
5.
Cutting head installation.
Install the guard bracket on the gear case. Align the hole in the faceplate with the hole
in the drive shaft tube and insert a latch. Attach the cutting head to the drive shaft tube
(counter clockwise). Remove the latch and tighten the head with a nut.
6.
Nylon line replacement
Before replacing the nylon line it is recommended to unplug the power cord from the
receptacle.
To replace the nylon line:
-
Press the two notches on the cutting head.
-
Remove the coil and the spring.
-
Run the nylon line through special holes in the coil.
-
Wind the nylon line according to the arrow mark.
-
Perform the assembly in reverse order.
7.
Guard and blade installation
Install the metal guard bracket on the gear case with the help of three mounting screws.
Install the guard bracket on the gear case. Install the blade between the lower and the
upper plates with nut. Make sure that locking pin is installed. Metal blade guard is used
only with metal cutting blade.
Abnormal vibration indicates that the blade is improperly installed. Stop the motor im-
mediately and check blade installation. Otherwise injury may occur.
safety instructions
ATTENTION!
All models of brush cutters may kick back stones, metal or small objects. Carefully read
the following safety instructions.
Observe instruction manual. Carefully study instruction manual in order to understand
the tool design and to know the purpose of all controls. It is necessary to know how to
stop the mechanism and turn off the motor. It Is necessary to know how to put off the
harness.
Never let inexperienced person operate the machine. Always wear heavy, long pants,
boots and gloves. Keep all children, animals, bystanders and helpers outside the 15 m
hazard zone.
ATTENTION!
Always wear heavy, long pants, boots and gloves. Do not wear loose clothing and, jew-
elry, short pants, sandals or go barefoot.