Zenith Victoria Pavilion Assembly Instructions Manual

Manual is about: Aluminum Hardtop Gazebo

Summary of Victoria Pavilion

  • Page 1

    Assembly instructions ltem: aluminum hardtop gazebo model: victoria pavilion zyg11-6.

  • Page 2

    P1 aluminum hardtop gazebo assembly instruction note: this unit is heavy! For safety, do not assemble this item alone. Six people are recommended for a safe assembly. A screw driver, hammer, two ladders (not included) with height no less than 2.5m are needed to install. For ease of identification wh...

  • Page 3

    A1 (x2) long right decorative beam b1 (x2) long left decorative beam c1 (x2) short right decorative beam d1 (x2) short left decorative beam e1 (x4) middle beam connector g1 (x4) corner connector a2 (x4) top slanting bar b2 (x2) middle beam of big top long side c2 (x2) middle beam of big top short si...

  • Page 4: Hardware Pack

    P3 e5 (x2) left roof cover of long side 3 f5 (x2) right roof cover of long side 3 g5 (x2) roof cover of short side 1 h5 (x2) left roof cover of short side 2 i5 (x2) right roof cover of short side 2 j5 (x2) left roof cover of short side 3 k5 (x2) right roof cover of short side 3 l5 (x4) top cover m5 ...

  • Page 5: Hardware Pack 2

    Aa 1/4" - 20×1 hex bolt 8 pcs 72 pcs 16 pcs 32 pcs 16 pcs 16 pcs cc 1/4" - 20×0.6 hex bolt dd 1/4" - 20×0.6 bolt ee 1/4" - 20×2.125 bolt ff 1/4" - 20 hexagon nut hardware pack 2 fig.5: attach the top short panel (m2) to the top long panel (l2) with bolts (aa) & washers (bb). Fig.6: attach the top sl...

  • Page 6: Hardware Pack 4

    Fig.11: insert the long side support bar (e3) & short side support bar (f3) into the corner pipe of bottom beam of small top (a3 & a6) as indicated in the figure. Fig.12: attach the assembled small top frame to the assembled big top frame as displayed in the figure. Fig.13: attach the connector of s...

  • Page 7

    Fig.15: lift the base protector (b4), attach the post base (a4) to the post (c4) with bolts (dd) & washers (bb). Fig.16: attach the top block (d4) to the post (c4) with bolts (cc) & washers (bb). (note: the screw holes on the post and the screw holds for installing the block plate (e4) should be in ...

  • Page 8: Hardware Pack 5

    Hardware pack 5 fig.22: press the left roof cover of long side 1 (a5) onto the right roof cover of long side 1 (b5) as shown in fig. 22, and insert into the u groove of b2 at the same time, as shown in fig. 22-1 fig.23: install the roof cover of short side 1 (g5) & left roof cover of long side 1 (a5...

  • Page 9

    Important: 1. Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area of pavilion construction. 2. The area for assembly should not be less than 6 feet from any obstruction such as fence, garage, house, overhanging branches, laundry line o...

  • Page 10

    P9 aluminum hardtop gazebo assembly instruction customer service zenith industries, lcc warrants to the original purchaser that this item is free from defects in work- manship and materials of your item provided the item was factory-sealed at the time of purchase and is maintained with care and used...