Zenith Victoria Pavilion Assembly Instructions Manual - page 7
Fig.15: Lift the Base protector (B4), attach the post base (A4) to the post (C4) with bolts (DD) & washers (BB).
Fig.16: Attach the top block (D4) to the post (C4) with bolts (CC) & washers (BB). (Note: the screw holes
on the post and the screw holds for installing the block plate (E4) should be in the same direction as
shown in the figure)
Fig.17: Lift the assembled pavilion roof and attach the assembled posts to the corners of the roof with bolts
(CC) & washers (BB).
(Note: The screw holes on the post must be directed inward. 6 people are needed here.)
Fig.18: Attach the Corner connector (G1) to the top block (D4) with bolts (CC) & washers (BB).
Fig.19: Attach the block plate (E4) to the top block (D4) with bolts (DD) & washers (BB).
Fig.20: Attach the arc support bar (F4/G4) to the post (C4) & decorative beam with bolts (CC) & washers (BB).
Fig.21: If placing the gazebo on soft ground, use ground stakes (HH) for added stability.
Fig.21-1: If placing the gazebo on the cement ground, fasten with concrete anchors (II).
P6
ALUMINUM HARDTOP GAZEBO ASSEMBLY INSTRUCTION
Fig.15
B4
A4
B4
A4
C4
G4
D4
Fig.20
F4
G4
D4
C4
C4
Fig.21 Fig.21-1
F4
Fig.16
Fig.17
D4
Fig.18
Fig.19