3Com BETA Getting Started Manual - page 11
Chapter 2. Overview of the Installation
•
Now you can see the main page of 3Com VCX IP Telecommuting Module. Click on the
Telecommuting Module Type
link and select the configuration for your Telecommuting
Module. The types are described on the corresponding help page.
•
Go to the
Basic Configuration
page and enter a
DNS server
. See also the
Basic Config-
uration
section.
•
Go to the
Access Control
page and make settings for the configuration of the Telecom-
muting Module. See also the
Access Control
section.
•
Go to the
Network Interface 1
page under
Network Configuration
and enter the neces-
sary configuration. See also the Interface section. Note that the Telecommuting Module
must have at least one IP address which can be reached from the Internet.
•
If one of the Telecommuting Module Types DMZ/LAN or Standalone was chosen, move
on to the
Network Interface 2
page and give the Telecommuting Module at least one IP
address on this interface and state the networks connected to the interface. See also the
Interface section.
•
Go to the
Default Gateway
page and enter a
Default gateway
. See also the Default
Gateway section.
•
Go to the
Networks and Computers
page. Define the networks that will send and receive
SIP traffic using the Telecommuting Module. Usually, you need at least one network per
interface of the firewall connected to the Telecommuting Module (or, for the Standalone
type, per interface of the Telecommuting Module). Some computers should be handled
separately, and they therefore need their own networks. See also the Networks and Com-
puters section.
•
Go to the
Surroundings
page (for the DMZ Telecommuting Module Type) and state the
networks connected to the
firewall
. See also the Surroundings section in chapter 8 of the
User Manual.
•
Go to
Basic Settings
under
SIP Services
and switch the
SIP module
on. Enter the port
range to be used by the Telecommuting Module for the media streams. See also the Basic
Settings section.
•
Go to the
Filtering
page under
SIP Traffic
to create
Proxy rules
for the SIP traffic from
different networks and allow the content types which should be allowed in the SIP media
streams. See also the Filtering section.
•
Go to the
Interoperability
page. Set
URI Encoding
to "Keep username in URIs".
•
Go to the
Save/Load Configuration
page under
Administration
. Select
Apply configu-
ration
. Now you can test your new configuration and save it permanently if you are sat-
isfied with it. If the configuration is not satisfactory, select
Revert
or restart the Telecom-
muting Module. The old configuration will remain.
•
When the configuration has been applied, you should save a backup to file. Press
Save to
local file
to save the configuration.
When the Telecommuting Module is configured, the firewall connected to it must also be
reconfigured (for the DMZ and DMZ/LAN Telecommuting Module Types).
3