3Com BETA Getting Started Manual - page 62
Chapter 6. Administration of the Telecommuting Module
Load from diskette
Insert the diskette with the saved configuration into the Telecommuting Module’s floppy
drive and press
Load from diskette
. Do not remove the diskette until the light on the floppy
drive goes out. The contents of the diskette are now loaded in the preliminary configuration.
Save to local file
Press
Save to local file
to save the preliminary configuration to the file you have selected. A
new window is opened where you enter the name of the file.
Load from local file
Press
Load from local file
to load a new preliminary configuration from the file you have
selected.
Browse
Browse
is used to scan your local disk. The web browser opens a new window where you
can search among files and directories. Go to the right directory and select the file you want
to upload.
Save/Load CLI Command File
All configurations can be saved to and loaded from a CLI file (see chapter 18 of the Refer-
ence Guide for more information about the CLI). You can also edit the CLI file before it is
uploaded again.
Uploading a CLI file might affect the permanent configuration, as the CLI file can contain
commands that applies the configuration.
Save config to CLI file
Press
Save config to CLI file
to save the preliminary configuration to the file you have
selected. A new window is opened where you enter the name of the file.
Load CLI file
Press
Load CLI file
to upload a CLI file to the Telecommuting Module.
Browse
Browse
is used to scan your local disk. The web browser opens a new window where you
can search among files and directories. Go to the right directory and select the file you want
to upload.
54