3Com BETA Getting Started Manual - page 48
Chapter 5. SIP Configuration
Domain
Enter the domain name of the SIP domain. This domain is compared to the domain in the
Request-URI of the incoming SIP packet.
You can’t enter a domain that was entered in the
Local SIP Domains
table.
Relay To
DNS Name Or IP Address
Enter the IP address for the SIP server handling the domain. You can also enter a DNS
name for the SIP server, if it has a DNS-resolvable host name, even if the SIP domain is not
possible to look up in DNS.
IP address
Shows the IP address of the
DNS Name Or IP Address
you entered in the previous field.
Port
Here, enter the port on which the SIP server listens for SIP traffic. The standard port is 5060
(5061 for TLS).
Transport
You can select which transport protocol to use between the Telecommuting Module and the
SIP server. Under
Transport
, select from UDP, TCP and TLS.
Priority
If you entered more than one IP address/host name for the same domain, you should also
assign them
Priority
and
Weight
. A low
Priority
value means that the unit should have a
high priority.
Weight
If more than one unit has the same
Priority
, the signaling sent to them is distributed between
them according to their
Weight
. If two units have the same priority, and Unit 1 has weight
4, and Unit 2 has weight 9, 4/13 of the signaling will be sent to Unit 1, and 9/13 will be sent
to Unit 2.
40