3Com BETA Getting Started Manual - General
Chapter 4. Network Configuration
The Telecommuting Module derives information about your network topology from the in-
terface configuration.
Telecommuting Module Type configuration
Current Telecommuting Module Type
Shows which type is currently active.
Change Telecommuting Module Type to
Select a new Telecommuting Module Type here.
Change type
Press the
Change type
button to set the new Telecommuting Module Type. This setting,
like others, must be applied on the
Save/Load Configuration
page before it affects the
Telecommuting Module functionality.
Interface (Network Interface 1 and 2)
There is a page for each network interface (Network Interface 1 and 2) on the Telecommuting
Module. Select a page to make configuration for that interface. There is also a page where
configuration for all interfaces can be viewed and changed.
Here, you set the interface name, whether the interface is on or off, the IP address, alias, and
static routing.
For each interface, go to
Directly Connected Networks
and state the IP address of the
Telecommuting Module and the size of the network connected to this interface.
General
19