3Com BETA Getting Started Manual - Backup
Chapter 6. Administration of the Telecommuting Module
Save configuration
saves your preliminary configuration to the permanent configuration
and puts it into use.
Continue testing
shows a new page with only the other two buttons.
Revert
cancels this test of the preliminary configuration without saving.
If you do not press any button within the time limit, the Telecommuting Module will revert
to the old permanent configuration, just as if you had pressed
Revert
. This is useful if you
happen to configure your Telecommuting Module so it isn’t accessible from your browser.
After the timeout, pressing either of the three buttons will show a new page which will
inform you that the test run was aborted.
Restarting the Telecommuting Module by cycling the power also cancels the test.
Show Message About Unapplied Changes
When there are settings which are not yet applied, a warning about this will be shown on
the web pages. Select here where this message should be shown. The options are
On every
page
,
On the Save/Load Configuration page
(this page) and
Never
.
Backup
All configurations can be saved to and loaded from diskette or file. This does not affect the
permanent configuration.
Save to diskette
Insert a formatted diskette into the Telecommuting Module’s floppy drive and press
Save to
diskette
to save the preliminary configuration. Do not remove the diskette until the light on
the floppy drive goes out.
Check that you get a confirmation of the saving. If not, the diskette may be faulty.
53