3Com BETA Getting Started Manual - Cancel
Chapter 6. Administration of the Telecommuting Module
Cancel
Reverts all the above fields to their previous configuration.
Look up all IP addresses again
Looks up the IP addresses for all DNS names on this page in the DNS servers you entered
on the
Basic Configuration
page.
This button will only be visible if a DNS server has been configured.
Save/Load Configuration
Here, you work with the preliminary and permanent configurations, save them and load new
configurations from previously saved configurations.
Test Preliminary Configuration
The settings you make in the web GUI will not be used automatically, but you must apply
them first. When there are settings which are not yet applied, a warning about this will be
shown on the web pages.
When
Apply configuration
is pressed, the Telecommuting Module will test the configura-
tion before you make it permanent.
During test, the Telecommuting Module waits for you to press one of the three buttons
displayed. If you never see the three buttons, something in your preliminary configuration
(now tested) is wrong, which makes it impossible for you to access the configuration web
interface.
Duration of limited test mode
Here, you enter the time limit for the testing. If you do not press any button within this time,
the Telecommuting Module will assume that some part of your preliminary configuration
makes connecting impossible. When the timeout is reached, the Telecommuting Module
automatically reverts to the old permanent configuration. If this occurs, you will be informed
when trying to press a button.
Apply configuration
Saves the preliminary configuration to the permanent configuration and puts it into use. You
can test your preliminary configuration before finalizing it.
Three buttons are displayed during the test:
52