3Com NETBuilder SI Using Manual - page 156

156

A

PPENDIX

 C: S

YNTAX

 C

ONVENTIONS

The following abbreviated command specifies that a neighbor on port 2 

network number &10 with address %080002030ef2 receives Routing 

Internet Protocol (RIP) and Service Access Point (SAP) updates:

ADD !2 -NRIP ATN &10%080002030ef2

The full form syntax:

SETDefault -IP CONTrol = ([ROute | NoROute], [RelaySrcRoute | 

NoRelaySrcRoute], [SplitLoad | NoSplitLoad], [Filtering | 

NoFiltering], [SECurity | NoSECurity], [FwdSubnetBcast | 

NoFwdSubnetBcast], [FwdAllSubnetBcast] | NoFwdAllSubnetBcast)

can be abbreviated to:

SETD -IP CONT = ([RO | NRO], [RSR | NRSR], [SL | NSL], [F  |  NF], 

[SEC | NSEC], [FSB | NFSB], [FASB | NFASB])

The following abbreviated command enables IP routing, packet filtering, 

and security:

SETD -IP CONT = (RO,F,SEC)

For consistency and clarity in the Enteprise OS and NETBuilder family 

guides, the full form syntax is provided. However, you can use the 

abbreviated form by only typing the uppercase portion of the command 

and supplying the appropriate values.

Variations in 

Command Syntax

Each command has its own syntax. When a command is used for 

configuring parameters, its syntax or values may change according to the 

parameter and the service. For example, the SETDefault command sets 

the NetMapTime parameter in the SYS Service and the MaxAge 

parameter in the STP Service. In the following example, the general 

command syntax is followed by the syntax variations (different values for 

different parameters) appropriate to the parameter associated with a 

service:

SETDefault =

SETDefault -SYS NetMapTime = (0 to 120 seconds)

SETDefault -STP MaxAge = (6–40)