3Com NETBuilder SI Using Manual - page 75
Configuring Serial Ports with DCEs
75
3 Set the baud rate (56 or 64 kbps) for the DS0 channel using:
SETDefault !
4 Set the path clock using:
SETDefault !
5 Re-enable the path using:
SETDefault !
The following optional settings are also available:
■
T1FrameMode
■
Superfame (SF)
■
Extended Superframe (ESF)
■
T1LineCoding
■
Binary with 8 zero substitution (B8ZS)
■
Alternate Mark Inversion (AMI)
■
Alternate Mark Inversion with bit 7 zero code substitution
(AMIB7ZCS)
Configuring Serial
Ports with DCEs
This section describes how to configure the serial ports with modems,
CSU/DSUs, or ISDN TAs attached.
Before beginning this procedure, complete the following tasks:
■
Cable the serial port and connect it to the telephone network.
■
Log on to the system with Network Manager privilege.
The serial port automatically detects the following settings:
■
Line type — dial-up or leased
■
Clock — external
■
Connector type — RS-232, V.35, X.21, RS-449, or RS-530
ISDN TAs
If you are attaching an ISDN TA, you must configure the TA with the
SPIDs, switch type, local telephone numbers, and Multilink PPP options
LH4 = 22.5 db
SH4 = 399 - 533 feet
SH5 = 533 - 655 feet