3Com OfficeConnect WX1200 Release Note - page 27
Known Problems
27
Web AAA client who fails authorization does
not receive a failure message. (17901)
If a user attempts to log in to the network on a Web
AAA login page served by the WX switch, but fails
authorization, the user does not receive a message
indicating that they have been denied access.
The display config command output lists the set
web-auth enable command even though this is
the default setting. (17332)
The display config command lists CLI commands
only for configuration settings that differ from the
default settings. However, the command lists the set
web-auth enable command when Web AAA is
enabled, even though Web AAA is enabled by
default. Normally, commands for default settings are
displayed only by the display config all command.
This issue is cosmetic only.
ACL Issues
ACE names that begin with CLI keywords are not
supported. (17521)
When configuring an access control entry (ACE), if
the name you specify for the ACE begins with a word
that is also a keyword used by the CLI, the CLI rejects
the ACE name. In the following examples, the ACE
names that begin with port and vlan are rejected, but
the ACE name that starts with abc, which is not a CLI
keyword, is accepted:
WX1200# set security acl ip port_abc deny
0.0.0.0 255.255.255.255
error: Wrong ACL name input = port_abc
WX1200# set security acl ip vlan_abc deny
0.0.0.0 255.255.255.255
error: Wrong ACL name input = vlan_abc
WX1200# set security acl ip abc_port deny
0.0.0.0 255.255.255.255
Do not use a CLI keyword in the beginning of an ACE
name.
ACL hits are not displayed for ACLS mapped only
to users. (15686)
If an ACL with the hit-sample-rate option enabled is
mapped only to a user (and not to a port or VLAN,
and so on), MSS does not display hit information for
the ACL. This issues does not affect ACLs that are
mapped to anything besides users. This issue also
does not affect the operation of the ACL. MSS cor-
rectly applies the ACL even if the hit data is not dis-
played.
The display security acl hits command does not
list any data when entered on a WX1200.
(18473)
Certificate Handling Issues
CLI omits the line feed after crypto certificate
commands. (14950)
When you type the crypto certificate admin or
crypto certificate eap command, the CLI incorrectly
echoes only a carriage return instead of echoing a
carriage return and line feed. This causes the cursor to
appear under the end of the previous row of output
instead of in the first column on the left.