3Com WL-560 User Manual - page 36
30
C
HAPTER
3: C
ONFIGURING
THE
B
RIDGE
Setting IP Network
Properties
Under System Configuration, click IP Network. TheIP Network Properties
page appears, where you can change the settings shown in Table 10.
If you change the IP address and click Apply, you cannot continue to
configure the device using the old IP address. Therefore, you must do the
following steps after changing the IP address:
1 Close your browser.
2 Return to the 3Com Wireless Infrastructure Device Manager and click
Refresh.
3 Select the device and click Configure to start a new configuration session.
Table 10 describes the IP Network properties.
Web GUI
Protocol
This setting allows users to enable the
secure data exchange scheme over SSL
during a configuration session.
HTTPS — enables SSL technology.
HTTP — disables SSL technology.
HTTP
WidMan RSSI
Monitor Support
When enabled, WidMan shows a graph
of the signal strength received by the
Bridge over time. To view the RSSI
monitor, click the device icon on
WidMan, click Properties, and then click
RSSI Monitor.
Enabling RSSI monitoring on WidMan is
helpful when making antenna
adjustments. You can ensure optimal
device placement and orientation based
on the signal strength shown on
WidMan.
Disable
Table 9 System Properties Page