3Com WL-560 User Manual - page 55
Configuring System Log Settings
49
Applying Settings
After you set the UART settings, network serial port settings or serial
telnet client settings, click Apply to apply them.
Configuring System
Log Settings
Under System Configuration, click System Log. The System Log page
appears where you can set syslog options.
Setting the System
Time
Under System Configuration, click SNTP. The SNTP page appears where
you can set time relevant options.
There are two ways you can set the system time on the Bridge:
■
By setting the time manually
■
By enabling the built-in Simple Network Time Protocol (SNTP) client
Table 17 System Log Settings
Setting
Description
Default
Syslog Server
The IP address of the syslog server on
the network
0.0.0.0
Syslog Port
The port number that the syslog server
uses to received log data
514
Syslog Level
Select the highest log level that you
want the Bridge to record. Options
include (from the highest to lowest):
■
Emergency - System is unusable
■
Alert - Action must be taken
immediately
■
Critical - Critical condition
■
Error - Error condition
■
Warning - Warning condition
■
Notice - Normal, but significant
condition
■
Informational - Informational
messages
■
Debug - Debug-level message
Error
CLI Logging
Select Enable to record all CLI
commands.
Enable
Web Audit
Logging
Select Enable to record all operations
executed on the Web interface.
Enable