3D Systems ProJet 4500 Installation Manual - page 13
Other manuals for ProJet 4500:
User Manual, Post Processing Manual
Manual is about: 3D Professional Printer
of
44
13
3D Systems, Inc.
INSPECT INTERIOR of PRINTER
9
IMPORTANT:
Initial installation of the printer should always be conducted with all external covers removed. Covers should not be rein-
stalled until all fluids have been loaded and fluid system has been confirmed free of leaks.
REMOVE COVERS
1. Lower Rear Cover:
Release the two handles. Cover will tilt towards you and
can be lifted clear.
2. Left and Right End Covers:
a. Have an assistant release the spring-loaded rod by pull-
ing as indicated.
b. As the assistant releases the rod, swing the bottom of
the end cover outwards and then lift up slightly to re-
move.
c. Repeat for the opposite end cover.