3D Systems ProJet 4500 Installation Manual - page 18
18
3D Systems, Inc.
INSTALLATION SCRIPT & FLUID LOADING PROCEDURE
10
IMPORTANT: Although the Installation Script on the printer LCD will walk you through many of the installation steps, it is important to refer
back to these instructions often for additional information that is critical for successful installation.
All network connections must be approved by the customer or customer’s IT manager prior to installation.
The most common methods of connecting the 3D Printer are as follows:
•
3D Printer connected to ethernet network running DHCP with dedicated computer connected to same network.
•
3D Printer connected directly to dedicated PC - Static IP Addresses are used on both devices.
1. Connect the Power Cord to the EBox.
Note that the cord must first be fed up through the opening in the bot-
tom of the printer (indicated by arrow). This is necessary to allow for
proper mounting of covers.
2. Connect Power Cord to AC main outlet.
NOTE: Most facilities have one (1) circuit breaker for five (5) or six (6) outlets. It is best to not share the circuit that the 3D Printer is using
with other equipment sharing the circuit that might exceed the wattage of the supplying circuit breaker and cause it to trip.
Ideally, an outlet on a dedicated circuit should be used for the 3D Printer.