3D Systems ProX DMP 300 User Manual - page 101
97
3D SYSTEMS, INC
.
PN:80-D27 Rev.B
21 . Ship the following to 3D Systems Customer Support:
•
Calibration plate: use a shock-resistant package that protects the plate from damage . Make sure to indicate the
serial number of the corresponding printer on a paper labelled on the back of the calibration plate .
•
Current correction file: send an email to
hotline .phenix@3dsystems .com
by attaching the correction file and
indicating the serial number of the corresponding printer .
22 . 3D Systems Customer Support will then give the result of the measurement:
•
If the result of the calibration is not correct, 3D Systems Customer Support will supply a new correction file (
xml
format); proceed then to the next section .
•
If it is correct, the printer calibration is validated .
Import a new correction file
The following steps must be performed as long as the calibration has not been validated .
1 .
Store the new correction file (
xml
format) supplied by 3D Systems Customer Support on a USB key .
2 . Install the USB key on the USB port (see "Second external controls panel" on page 32) .
3 . Make sure to access to the control software by using
the
Adjuster
level (see "User level selection" on page
51) .
4 . Access to the
Configuration
tool .
5 . Go to the
Optic
menu (1) .
6 . Click on the
Import
button (2) .
7 .
Select the new correction file, then validate. The new
correction will replace the previous one (confirm the
overwriting message if displayed) .
8 . Draw a new calibration plate (see page 95) .
9 . To control and validate the new calibration, ship the following to 3D Systems Customer Support:
•
Calibration plate: use a shock-resistant package that protects the plate from damage . Make sure to indicate the
serial number of the corresponding printer on a paper labelled on the back of the calibration plate .
•
Current correction file: send an email to
hotline .phenix@3dsystems .com
by attaching the correction file and
indicating the serial number of the corresponding printer .
10 . 3D Systems Customer Support will then give the result of the measurement:
•
If the result of the calibration is not correct, 3D Systems Customer Support will supply a new correction file (
xml
format); repeat steps from 1 to 10 .
•
If it is correct, the printer calibration is validated .
7
COPYRIGHT AND TRADEMARK NOTICE
Copyright © 2017 3D Systems, Inc . All rights reserved . Subject to change without notice . This document is copyrighted and
contains proprietary information that is the property of 3D Systems, Inc . 3D Systems, the 3D Systems logo, and ProX are
trademarks of 3D Systems, Inc .
2
1