3D Systems ProX DMP 300 User Manual - page 70

66

3D SYSTEMS, INC

.

PN:80-D27 Rev.B

CLOSING / OPENING PX CONTROL APPLICATION

1 .  Click on the 

 button (1) .

2 . 

Click “Yes” on the “PX Control : Closing” message.

SHUTTING PRINTER DOWN

1 .  Click on the 

 button (1) .

2 . 

Click “Yes” on the “PX Control : Shuttdown” message. The complet 

shutdown of the machine takes about 30 seconds (shutting down the 

system control) . Then push the start button to switch off .

The shutting printer down procedure will only switch off the printer, it will not be de-energized . To de-

energize the printer, refer to the section "Powering down the printer" on page 66) .

POWERING DOWN THE PRINTER

1 . 

The printer must be at first switched off (see section "Shutting printer down" on page 66).

2 .  Close the gas valve (1) and compressed air valve (2) on the supply cabinet .

3 .  Switch the locking key to position "0" on the external conrtols panel .

4 .  Switch off the two UPS (see "H . Supply cabinet" on page 33) .

5 .  Turn off the main switch on the connection panel of the supply cabinet (3) .

To relaunch the PX Control application, double-click on the icon 

 “PX_Control”, from the desktop.

3

1

2

1

1