3D Systems ProX DMP 300 User Manual - page 44

40

3D SYSTEMS, INC

.

PN:80-D27 Rev.B

Step 1 : Initialization

For each new job preparation, the printer must be initialized at first. The initialization step is performed automatically:

1 .  Click on the automatic cycle launch button (1) .

2 .  When automatic cycle completed, click on 

Next

 (2) to go to the next step .

1

2

Step 2 : Unloading plate

NOTE: If there is no sintering plate to unload, the step 2 

is not to be performed. In this case, confirm the pop-up 

message to go directly to the next step .

This step includes both manual and automatic actions, divided in 4 sections :

A .  Plate cleaning (including the recycling and unloading plate cycles)

B .  Carriage cleaning and unloading plate

C .  Gas diffuser cleaning

D .  Chamber cleaning

During the step 2:

1 .  Perform the actions (1) by using the available 

commands (2) and the external controls panel . 

Consult the section "Unloading a plate" on page 

64 for details .

2 .  Click on the automatic cycle launch button (3) when 

requested .

3 .  When the 4 sections are complet, the next step will 

be enabled . Click on 

Next

 (4) .

1

3

2

4