3D Systems ProX DMP 300 User Manual - page 40
36
3D SYSTEMS, INC
.
PN:80-D27 Rev.B
LIFTING
Caution : Moving the printer may affect settings (alignments, calibration . . .) . Contact your 3D Systems-
certified Customer Support Engineer to check the operation of the printer after moving.
When moving the ProX
®
DMP300 system, follow the instructions outlined below :
•
The system must only be lifted by authorized people .
•
Make sure entire lifting, rigging and supporting structure has been inspected, and is in a good condition .
•
The main cabinet can be moved by using a forklift with a load capacity of at least 8000 kg (minimum fork length of 1800
mm) .
•
When moving the system, make sure to insert the
forks as indicated on the picture . This is required
because the center of gravity of the printer is forward
of the center line .
•
The control cabinet and the supply cabinet are easily
moved as they are equipped with transport wheels .
Rear
Front