AAS PhoneLink 500 Installation And Programming Instructions - Phonelink 500 Keypad
13
- The
Event
Input’s REMOTE OPEN mode is not disabled in any operational
mode except programming.
PhoneLink 500 Keypad
ACCESS & FUNCTION CODES
Depending on which model you have, your unit may be programmed with 500 (4
digit) access codes. There are two different types of codes, access codes &
function codes. Although the number of access codes will vary with each model,
the number of function codes is always 4.
These codes can be programmed
with the PhoneLink keypad and/or your Telephone keypad(See calling a
gate).
FUNCTION CODES
"MASTER CODE"
This code is a programmable four digit code
used
for
gaining
access
to
the
program
mode.
It does not activate the control relay.
The factory default master code is 1 2 5 1.
"LATCH CODE"
This code is a programmable four digit code
used to Activate relay A. This code will be used
to hold open a gate or door.
"SLEEP CODE"
This code is a programmable four digit code
which, when entered, will disable all standard access
codes.
When
the
"SLEEP CODE"
is entered again the
unit
will
be
enabled.
An
override code is provided.
“ONE SHOT CODE”
This code is a programmable four digit code that
disables itself after one use. The user can enable this
code for reuse using the keypad or telephone.
GOODBEEPS & ERRORBEEPS
Your unit will beep each time a key is pressed. The
"*"
key serves as the clear
key and a double beep will be heard when this key is pressed. A
"GOODBEEP"