AAS PhoneLink 500 Installation And Programming Instructions - page 20
20
The Relay # corresponds to which relay to set. 1 = Relay A, 2 = Relay B.
Should you make a code entry error, simply press the * key and enter the correct
code. Your output time is set on both relays from the factory at approximately
1/2 seconds "00". If a longer output time is desired, enter a two digit number
corresponding to the number of seconds between "00" and "99". By entering
"00" the output time is set to approximately 1/2 seconds which is ideal for most
operators.
Sub-Mode 7 (Program Relay B Access Codes)
To program new Relay B access codes enter the following;
(MASTER CODE) + 7 + (NEW CODE) + (NEXT NEW CODE)
etc......... (
#
to exit)
Should you make a code entry error, simply press the * key and enter the correct
code. You may select any 4 digit code you wish. If you receive an
ERROR
after
entry, you must select another code as it is already in use. The unit will respond
with a
GOOD BEEP
with the acceptance of each new Relay B code. You may
continue entering Relay B codes until you finish (Press
#
), or the memory
becomes full. You will automatically be exited from the program mode if the
memory reaches capacity. When memory is full you will not be able to enter this
Sub-Mode and will receive an
ERROR
if entry is attempted.
Sub-Mode 8 (Enable/Disable 3 Strikes-You’re Out)
EXPLANATION: This feature is desirable to keep unwanted persons from
successively entering codes until they "hit" a programmed access code. By
selecting this function you enable a 1 1/2 minute lock out period if 3 incorrect
codes are entered successively within a 3 minute period. When this occurs, the
LED's
will flash and a high pitched alarm will be generated from the unit for 30
seconds. The unit will then shutdown for 1 minute.
To Activate the 3 strikes-you’re out feature enter the following;
(MASTER CODE) + 8 (*current state) + (MASTER CODE)
*current state
single beep = 3 strikes enabled
double beep = 3 strikes disabled
Should you make a code entry error, simply press the * key and enter the correct
code. After you have selected mode 8, the unit will respond with a single or
double beep. A single beep indicates that the 3 strikes-you’re out feature is
presently enabled. A double beep indicates that the 3 strikes-you’re out feature