AAS PhoneLink 500 Installation And Programming Instructions - page 17
17
exception of the
MASTER CODE
. If the code you wish to delete is not found in
memory, the unit will respond with an
ERROR
and wait for another code to be
entered. A
GOOD BEEP
will be sounded once the code has been found and
deleted. You may continue deleting codes until you finish (Press
#
).
Sub-Mode 3 (Change MASTER CODE)
To change your master code enter the following;
(present MASTER CODE) + 3 + (new MASTER CODE)
Should you make a code entry error, simply press the * key and enter the correct
code. You may select any 4 digit master code you wish. If you receive an
ERROR
, you must select another code as it is already in use. The unit will
respond with a
GOOD BEEP
with the acceptance of the new Master Code and
you will be exited from the program mode.
MAKE SURE TO WRITE THE NEW
MASTER CODE DOWN.
Sub-Mode 4 (Set Sleep Code and/or Latch Code and/or Call
Forwarding
)
EXPLANATION: The sleep code used to disable all Relay A and function codes
from the keypad. It also turns shuts off the
CALL
button on the intercom. This
feature is most commonly used in applications where no entry is desired after
hours. Relay B codes will still be valid from the keypad. By connecting both
relays in parallel, managers may be assigned RelayB codes and still gain
access. While in the
SLEEP MODE
, the yellow and red
LED's
will flash
approximately once every 3 seconds. To initialize the system back to normal,
simply re-enter the sleep code. Should you lose or forget your sleep code and
the unit is in the sleep mode see the Unit Reset instructions on page 15.
NOTE: You can also Activate the sleep code with the telephone. (See
intercom operating instructions.)
A. Set Sleep Code
:
To program or change your sleep code enter the following;
(MASTER CODE) + 4 + 1 + SLEEP CODE
Should you make a code entry error, simply press the
*
key and enter the correct
code. You may select any 4 digit sleep code you wish. If you receive an
ERROR
, you must select another code as it is already in use. The unit will