AAS PhoneLink 500 Installation And Programming Instructions - * * *
14
is represented by an oscillating high tone. An
"ERROR BEEP"
is represented by
a single low tone.
THE RED & YELLOW LED's
Two different colored LED's are in the face of the unit. The red LED will light
during the duration of the relay(s) activation period. The yellow LED will light
while the unit is in the program mode. During memory erasure or setup the
LED's will flash.
RESETTING THE UNIT
Your unit provides 2 different types of resets, a
Unit Reset
, and a
Master Reset
.
A
Master Reset
should be utilized in the event that you lose or forget your
master code or if the unit is in the Latch or Sleep mode and the Latch or Sleep
code is lost or forgotten. When a
Unit Reset
is performed, the master code will
be set back to 1 2 5 1.
A Unit Reset is provided to reset the unit back to the initial factory state. After a
Unit Reset
has been performed the unit will
DELETE ALL ACCESS &
FUNCTION CODES
and the master code will be set back to 1 2 5 1.
MASTER RESET
Follow these steps precisely. If you make an error, the unit will
ERROR
and you
will have to start over.
Press and hold the RESET BUTTON, then press and release the SETUP
BUTTON. Release the RESET BUTTON and the unit will go into a endless tone
cycle.
Enter
* * *
from the keypad.The unit will go into a endless tone cycle.
Press and release the SETUP button and the master code will be set back to
1 2
5 1
. If you previously were in the sleep or latch mode, the unit will be brought
back to normal idle mode.
UNIT RESET
(!!!!! WARNING: ALL CODES WILL BE DELETED FROM MEMORY !!!!!)