AAS PhoneLink 500 Installation And Programming Instructions - # * #
15
Press and hold the RESET BUTTON, then press and release the SETUP
BUTTON. Release the RESET BUTTON and the unit will go into a endless tone
cycle.
Enter
# * #
(The unit will respond with a
GOOD BEEP
)
Enter the
MASTER CODE
from the keypad. (The unit will flash the
LED's
several times and then go into an endless tone cycle)
Press and release SETUP BUTTON.
The idle mode
The idle mode is the normal mode of operation. When in this mode the unit sits
and waits for data from the keypad. When in this mode you will have
approximately 4 seconds between keypresses. If this time is exceeded, you will
receive an
ERROR BEEP
.
The Program Mode
The program mode is the mode of operation in which you will enter, delete, or
change your codes or set specific features of the unit. The program mode is
accessed by entering the
"MASTER CODE"
from the keypad. You will receive a
GOOD BEEP
and the yellow
LED
will come on indicating that you are in the
program mode. In this mode you will have approximately 30 seconds between
key presses. If this time is exceeded, you will receive an
ERROR BEEP
and be
exited from the program mode.
The
*
and
#
Keys
The
*
and
#
keys serve specific functions while in the idle or program mode.
The * key is always the
Clear
key and a double beep will be heard when
depressed. You should use this key if you make an entry error. The
#
key also
serves as the clear key in the idle mode. In the program mode however, it
serves as the exit key and will at any time when depressed, exit you from the
program mode.
PROGRAMMING
A person desiring access to the program mode will enter the present
MASTER
CODE.
If the master code is valid the yellow
LED
will come on and the you will
be prompted with a
GOOD BEEP
to enter a number corresponding to a
SUB-
MODE
.
Remember: MASTER CODE will not activate the control relay.
(MASTER CODE)
+ (Number corresoponding to Sub-Mode).