Aastra 9112I User Manual - Getting Started
2
Model 9112i SIP User Guide
Getting Started
Getting Started
The 9112i must be set up and
configured prior to its first use. This
section describes phone behaviour
and start up screens you may see
when the phone is first plugged in,
or when it is restarted.
When You First Plug in Your
Phone
The 9112i automatically begins the
start up sequence as soon as it is
connected. The phone goes through
this process the first time you plug in
your phone and every time you restart
your phone. The first screen the phone
displays is the Aastra splash screen.
Updating Your Phone
After displaying the Aastra splash
screen, the 9112i checks settings and
looks for new configuration and
firmware updates for the phone from
the server. If a new update is found,
the phone displays the message
“
Updating Config
” or “
New Firmware
”.
This may take a few moments while
the phone downloads the latest
updates.
NOTE:
New updates to your phone can be
automatically scheduled from the
server. This is set up on the phone
system by your system administra-
tor and should be scheduled dur-
ing non-business hours or slow call
periods.
Important! Do not unplug or remove
power to the phone while it is checking or
installing firmware.
Start up Screens
After the phone displays the Aastra
splash screen or after downloading an
update (if an update was available),
the phone displays the
Idle State
screen:
The basic
Idle State
screen lists your
name, extension, and today's date and
time. This screen is shown whenever
your phone is not in use.
Incomplete Config.
If your phone displays a “
No Service
”
message without any extension or
user name at the end of the start up
sequence instead of the
Idle State
screen, this means your system
administrator has not set up your
extension correctly. Contact your
system administrator for assistance.
No Service
The “
No Service
” or “
Network
disconnected
” prompt appears on the
display and the telephone status light
turns on when the phone is not
properly connected to the network, or
the account has not been configured
by the administrator. The phone also
displays the default time and date of
12:00am Jan. 1st, 2000. Check that the
cables are tightly connected to the
phone and to the wall jack. The phone
should automatically detect when the
connection is reconnected and will
display the “
Network Connected
”
prompt temporarily. If changes have
been made to your phone settings,
you may need to restart your phone.
See the following section
Aastra 9112i
Cheking for new
firmware...
John Burns
9054550055
Jun 8 2:55pm