ABB i-bus KNX FCL/S 1.6.1.1 Product Manual - page 59
ABB i-bus
®
KNX
Start-up
FCL/S x.6.1.1 | 2CDC508116D0203 57
Enable communication object
"Status Switch" 1 bit
Options:
No
Yes
Yes
: The following parameters appear:
Send object value
Options:
No, update only
Only after changing
After request
After a change or request
No, update only
: The status is updated but not sent.
Only after changing
: The status is sent after a change.
After request
: The status is sent after a request.
After a change or request
: The status is sent after a change or a request.
Object value of contact position
Options:
1 = closed, 0 = open
0 = closed, 1 = open
This parameter defines the communication object value of the switch status (
Status switch
).
1 = closed, 0 = open
: A closed contact is represented by communication object value 1 and an
open contact by 0.
0 = closed, 1 = open
: A closed contact is represented by communication object value 0 and an
open contact by 1.
Note
The contact position and thus the switch status can be the result of a series of priorities and
links.