ABL eMH1 Instruction Manual - page 13
inStallatiOn and pOwer Supply cOnnectiOn
9
DANGER!
In case of visible damage to the Wallbox occurring during installation or
use, the device must be taken out of operation immediately, as
this poses
a danger to life and limb.
In this case, replacement of the Wallbox is required!
• Outdoors the Wallbox should only be installed in covered locations that provide suf-
ficient protection from rainwater. Installation in a garage or car-
port is recommended, as long as it fulfills the stated require-
ments.
• The recommended installation height is 50 to 150 cm from the
floor to the lower edge of the housing.
• The required mounting area for the model variants of the eMH1
Wallbox described in this manual is at least 262 x 222 mm (H
x W).
• The mounting area must have an even surface that provides
sufficient stability for installing the eMH1.
• Choose a mounting site that allows you to reach the charging
socket of your vehicle comfortably with the charging connec-
tor of the eMH1: The cable must not under any circumstances
be strained when connected to the vehicle.
Preparation and mechanical installation
After determining the mounting site for the eMH1, you can begin with the mechanical
installation. For installation you will need the following components:
• Power drill or cordless drill (not included)
• Drill bit Ø 8 mm, appropriate for the wall material (not included)
• Pliers or cutter for breaking or cutting out the cable inlet in the rear part of the hous-
ing of the eMH1 (not included)
• Three flat-headed screws size M5 x 60, fully or partly threaded, with a head diam-
eter of 8.5 mm ± 1 mm (not included)
• Nylon wall plugs 8 x 40 mm suitable for the wall material (not included)
• Drilling template for the eMH1 model variants described in this manual (included)
• Spirit level if required (not included)
CAUTION!
C
heck the measurements on the drilling template with a calibrated mea-
suring tape BEFORE you mark the drill holes using the template and then
drill them.
50 to
150 cm