ABL eMH1 Instruction Manual - page 7
Safety and Operating nOticeS
3
• Ensure that the rated voltage and rated current of the device comply with the pa-
rameters of your local electricity grid and that the rated output is not exceeded dur-
ing charging operations.
• At all times comply with local safety regulations for the country in which you operate
the device.
• To disconnect the device completely from the power grid, the power supply must
be cut at your domestic miniature circuit breaker (MCB).
• Follow all information and instructions of the manufacturer for installing
and operating the device.
• Do not operate the device in confined spaces.
• Make sure that the front cover shield is always locked to prevent unauthorized open-
ing of the housing. Keep the key in a place that is known to all authorized users.
• You must under no circumstances make any changes to the housing or the internal
wiring of the device: Any disregard of this instruction fundamentally breaches the
guarantee provisions and voids the warranty with immediate effect.
• No parts to be maintained by the user are located inside the device.
• Only have qualified, specialist personnel repair and/or install the device.
WARNING!
This Wallbox is intended for connection to and operation on 230 or 230
/ 400 V 50 Hz mains power only. Power supply cables may be installed
below or above the wall surface. The cable should enter the device on the
underside of the rear part of the housing (see page 10).
• Only use a dry cloth to clean the device. Do not use aggressive cleaning agents,
waxes or solvents (such as cleaning fluid or paint thinner), because they can dull the
displays on the device.
• The Wallbox must never be cleaned using a pressure cleaner or similar implement.
• Check the permanently installed charging cable of your eMH1 Wallbox regularly for
potential abrasions or damage.
DANGER!
Should you discover any damage to the charging cable or a supply cable, you
must take the device out of operation immediately. In this case, please turn
to an authorized service partner or the dealer from whom you purchased
the product. You must not under any circumstances attempt to resolve or
repair any damage or malfunction yourself!
• Relevant local regulations for operating electrical devices always apply.