Accutome ACCUPEN User Manual - page 14
9
(800) 979-2020 US & CA • (610) 889-0200 International • +31 (0) 485-350300 Europe •
www.accutome.com
CAUTION: Use only the style and type of battery specified. Using another style or
type of battery may cause damage to the product and invalidate the warranty.
Battery Installation
CAUTION: The battery is polarized so that it only fits into the battery compartment one way.
Check to be sure that the battery is installed correctly, and do not force
the battery into place. Incorrect battery installation could cause severe damage to the
product and invalidate the warranty.
To install the battery in the AccuPen:
1. Locate the battery compartment
(as shown in Figure 3.2) on the
bottom of the AccuPen and open
the compartment by unscrewing
the battery door screw. The battery
door is hinged to the bottom of the
handle and should not be removed
from the product.
2. Insert the XENO model XLP-050F
lithium battery, or an equivalent,
into the battery compartment as
shown in Figure 3.2.
3. Close the battery compartment
door and screw the captive
battery door screw back into
position to firmly hold the battery
compartment door in a closed position.
Do not over tighten the screw.
Instructions for Use
CAUTION: Do not Autoclave the AccuPen Tonometer.
Initial AccuPen Tonometer Setup
The followiing steps outline the basic setup of the AccuPen.
1. If the battery is not installed in the AccuPen, install the battery as described
in “Battery Installation” on page 5 and 6 of this guide.
2. To return to the Measurement screen, press and hold the Action Control
button for 2 to 3 seconds until the Measurement screen appears.
Figure 3.3 - Action Control Buttons and LCD
Figure 3.2 - Battery Insertion
Up Button
Action Control Button
Down Button
Getting Started